Unedited
Real laundry rooms. Real first pull-outs.
Swipe to see more →
The six inches behind your washer
You haven't cleaned back there in years. It isn't because you don't care.
- It weighs somewhere north of 200 pounds and it will not budge.
- Last time you shoved it, you heard the floor complain.
- The dryer vent hose is back there. So is a decade of lint.
- Every sock and cat toy you've lost is under it.
- So you stopped trying, and you stopped thinking about it.
Someone on a home forum described it perfectly: “the dust is so old it’s like stuck to the ground.” That's the part nobody says out loud — it isn't dust anymore. It's a surface.
What's actually under there
The one place in your house you've never inspected
Behind a dryer sits the vent hose. Lint packs into it slowly, year after year, and a blocked vent doesn't just make your clothes take two cycles — restricted dryer airflow is a well-documented fire risk. It's also the one hose in your home you physically cannot get to.
Under a washer, it's moisture. A slow weep from a hose fitting doesn't announce itself. It just sits there, under 200 pounds of steel, doing damage to a floor nobody can see.
“I can vacuum the floor, dust the wall, retrieve lost items and most importantly remove the vent hose for a thorough cleaning. So much lint build-up!”
Stanley — verified buyer
You've probably already tried
Why none of it actually worked
-
×Shoving it
Rubber feet on a hard floor don't slide. They grip, then let go all at once. That's how floors get gouged — not from the weight, from the sudden release.
-
×Glass cleaner, carpet scraps, cardboard
Real advice, from a real forum thread, given to someone who couldn't move their washer to change a belt. It works once, badly, and you redo it every time.
-
×Furniture sliders and felt pads
Sized for a sofa, not for 200+ pounds concentrated on four small feet. They compress, tear, and grind through.
-
×Asking someone to help
Assumes someone is available, willing, and able — every single time you want to clean. Most people ask once, nearly drop it, and never ask again.
-
×Calling a pro
One buyer paid a local appliance company $175 to come out, clean the vent and put everything back. For a job that takes twenty minutes once you can reach it.
The actual fix
Stop dragging the weight. Start rolling it.
Two adjustable steel rails go under the appliance — one front, one back. The feet rest on padded contact points. The rails carry the load on 24 wheels instead of four rubber feet.
The same mass that made it immovable now makes it stable. Heavy on wheels rolls smooth and tracks straight. Heavy on feet just sticks.
Load spread across two dozen contact points instead of four. Lower pressure per wheel means it rolls instead of digging.
Step the brakes down and it's planted for wash day. Release them when you want the floor back. A switch, not a decision.
Not a spec — a safety feature. Rails set to your appliance's actual footprint keep the load centred so it can't rock.
Swipe →
It stays under the appliance permanently. You're not installing it each time — you set it once and then the machine simply moves whenever you need it to.
The question everyone asks first
“How do I get a 200-pound machine onto it?”
Fair question. Most pages selling these skip it entirely. Here are the three ways people actually do it — pick whichever fits your situation.
The tilt method — one person, no tools
Tip the appliance back onto its rear feet, slide the front rail underneath, set it down. Repeat from the front for the rear rail. You're never lifting the machine — you're pivoting it a couple of inches at a time.
With a lever — the easiest version
A simple appliance lever bar lifts one edge a few inches with almost no effort, leaving both hands free to slide the rail in. If you have any doubt about the tilt method, this is the one to use.
At delivery — the free version
If a new washer or dryer is being delivered, have it set straight onto the rails. Buyers report install crews doing this without being asked twice. Zero lifting on your part.
Tap to watch
What you get back
The floor you forgot you owned
Reach the dryer vent
Pull the machine out, detach the hose, clear years of packed lint, put it back. Twenty minutes, no appointment, no $175.
Clean behind and underneath
Vacuum the floor, wipe the wall, find whatever's been under there since you moved in.
Check for leaks before they cost you
A slow drip under a washer stays invisible until the floor is ruined. Now you can look whenever you want.
Get at the hoses and the back panel
Swapping a belt, reversing hot and cold, checking a fitting — all of it needs access to the back. This gives it to you.
Do it without asking anyone
One person, one hand, brakes off. No favours, no scheduling, no waiting for the weekend.
Move it without marking the floor
Rolling replaces dragging. The wheels carry the load instead of the appliance feet scraping across it.
“My husband and I got the washer and dryer out with difficulty, but after placing them on these it was so easy to maneuver them back into place. We are 73 & 67 yrs. old.”
Getting them on took effort. Everything after that didn't.
Before you order
Two measurements, sixty seconds
Check these first — we'd rather you didn't order the wrong thing
- The width across your appliance feet. The rails extend from roughly 17.1″ to 27.3″. Measure foot-to-foot, not the cabinet edge.
- Your clearance above. This raises the appliance about 1.5″. If it lives under a countertop or in a tight closet, measure the gap you have now.
- Your hose slack. To roll the machine out, the water lines, drain hose and cord need enough give to travel with it. Longer hoses are cheap; discovering this mid-job is not.
- Your floor type. Hardwood and tile: no issue. Soft vinyl or linoleum: read the section below before you order.
If any of these don't clear, this isn't the product for you — and we'd rather tell you now than process a return later.
Straight answers
What this doesn't do
The wheels are hard — mind soft flooring
On hardwood and tile they're fine. On soft vinyl or linoleum, a heavy appliance parked in one spot for months can leave impressions. If that's your floor, put a hardboard panel underneath or choose a different solution.
Use the rubber wedges. Every time.
The brakes hold for normal use, but the wedge stops that ship in the box are what keep the rails from creeping under long-term vibration. They're not an accessory. Set them once the machine is in position and leave them there.
It rolls in a straight line, not sideways
Front-to-back travel — out and back in. It isn't a swivel dolly. For most laundry alcoves that's exactly what you want, but it's worth knowing.
It's not a moving dolly for stairs
This is for repositioning an appliance within a room. Moving house is a different job and needs different equipment.
Check the rails seat flat every few months
Takes ten seconds when you're already back there cleaning. If a contact pad has shifted, reseat it before you roll.
We put this section on the page because the alternative is you finding out later. Every product has edges — the ones that hide them are the ones you end up returning.
The numbers
Specifications
Rated load is the manufacturer's figure for the pair. Household washers and dryers typically run 150–250 lbs; a full side-by-side fridge can exceed that, so check your appliance's spec plate before ordering.
Once, then never again
Setting it up
Measure and set the rails
Extend each rail to match your appliance's foot spacing and tighten the wing nut. Two minutes.
Get the machine on
Tilt, lever, or have it set down at delivery. Front rail, then rear. The feet sit on the padded contact points.
Position, brake, wedge
Roll it where it lives, step the brakes down, seat the rubber wedges. It's parked.
Roll it out whenever you want
Wedges out, brakes up, pull. Clean, inspect, repair, roll it back. That's the whole thing, forever.
Verified buyers
What people report back
You need these if you want to get behind your dryer
"My dryer sits on a pedestal drawer and I could not move it out to clean the vent hose. Now the whole stack just glides out once I release the brake. I can vacuum the floor, dust the wall, get lost items, and finally pull the vent hose off. So much lint build-up. A must have."
Best thing I've bought in years
"Bought these so I could clean underneath and get to the dryer vent. Once the units were on I was blown away at how sturdy it is and how easy the big uprights move. They glide where you want and after locking them they stay put. My husband and I are 73 and 67 — we managed it ourselves. Ordering another set for the sleep sofa."
Waited a month before writing this
"Wanted to be sure they worked before reviewing. They do. On stone tile they roll in and out no problem and they do not move during use. They even lift the washer and dryer a bit higher, which was an unexpected bonus. I'm the guy who cleans dryer vents now and then, and I paid $175 last time to have someone come do it. Wish I'd had these twenty years ago."
Machine hasn't moved an inch
"Very easy to install and I pushed my stackable right back into the closet space it came out of — which I had a heck of a time getting out in the first place. Been using them a month now and they're still exactly in place. They have the brake and they also came with little rubber chocks for under the wheels. One of the best purchases I've made."
My flooring guy called it brilliant
"Kitchen remodel — we were trying to figure out how to move a giant old stove in and out around the new hardwood. These saved the day. I can roll the stove out to clean under it and it's genuinely easy now. The locking mechanism works and it hasn't damaged the floor at all."
Quick to assemble, easy to use
"Measure the length, set the wing nut, put them under the appliance, position it, press the brake down. That's it. I had them in when my new washer and dryer were delivered and the installers were impressed at how easily they could move everything. Needed it straight away too — they'd reversed the hot and cold feeds and I had to get behind the washer to fix it."
Money-back guarantee. No questions asked.
Put it under your own machine and use it. If you don't love it, email us within 30 days and we'll refund you. No forms, no explanations, no hoops.
Before you ask
Questions we get a lot
How do I get the appliance onto it by myself?
Three ways: tilt the machine back onto its rear feet and slide the rail under, use an appliance lever bar to lift one edge, or have it placed on the rails when a new machine is delivered. The tilt method needs no tools. Watch the videos above — this is the part most pages skip, so we put it front and centre.
Will it fit my washer / dryer / fridge?
The rails adjust from about 17.1″ to 27.3″. Measure the distance between your appliance's feet — front to back — not the width of the cabinet. If that measurement falls inside the range, it fits.
Will my machine shake or walk during the spin cycle?
With the brakes engaged and the wedge stops seated, buyers consistently report the machine staying put. Do use the wedges — they're what stops any long-term creep from vibration.
Will it damage my floor?
On hardwood, tile and sealed concrete, no — rolling puts far less stress on a floor than dragging does. On soft vinyl or linoleum, a heavy appliance parked in one place for months can leave impressions, because the wheels are hard rather than soft rubber. Put a hardboard panel underneath if that's your flooring.
Is 660 lbs real?
That's the manufacturer's rating for the pair of rails. A typical household washer or dryer is 150–250 lbs, comfortably inside it. Large side-by-side refrigerators can run heavier — check your appliance's spec plate, usually inside the door frame.
How much taller will my machine sit?
About 1.5 inches. If your appliance lives under a countertop or in a closet, measure your existing clearance first. Some people consider the extra height a bonus — it improves airflow and keeps the base off a damp floor.
Will my hoses and cord reach when I roll it out?
Depends on your setup. Before ordering, pull gently on the water lines, drain hose and power cord to see how much slack you have. If it's tight, longer hoses are inexpensive and worth sorting out in advance.
Does it work on carpet?
Not well. Wheels need a hard, flat surface to roll on. On carpet the wheels sink and you lose the benefit entirely.
Can I leave it under the appliance permanently?
Yes — that's the intended use. Brakes down and wedges in for daily use, released when you want to roll it out. Check every few months that the contact pads are still seated flat.
Do I need tools to assemble it?
No. Each rail extends to length and locks with a single wing nut you tighten by hand.
30-day money-back guarantee · No questions asked
- Steel frame
- Fits 17″–27″
- No tools needed
- Brakes + wedge stops
Measure your appliance and your clearance before ordering. Place the unit on a flat, stable surface and engage the brakes and wedge stops before operating the appliance. Not intended for use on carpet or for transporting appliances up or down stairs.